Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod SSR

The Pmod SSR is a solid state relay that features IXYS' CPC1908J. The Pmod SSR uses a switch controlled by a single GPIO pin and is rated to block up to 48 Volts and switch up to 6 Amps (rms) continuous current.

Features

0-48 V blocking voltage
Can switch up to 6 Arms continuous current
2500 V input/output isolation
Low on resistance with fast turn on/off
Onboard LED to indicate on/off state
Onboard terminal block for easy wire connection
Small PCB size for flexible designs 1.7" × 0.8" (4.3 cm × 2.0 cm)
6-pin Pmod Connector with GPIO interface
Follows the Digilent Pmod Interface Specification Type 1

Scope of Delivery

1 x Pmod SSR in a custom antistatic Pmod packaging

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: Pmod SSR: Solid State Relay Electronic Switch
Manufacturer's article number: 410-342

Resources

Other Digilent products are available on request.

Caractéristique technique	Valeur
ID de l’art.	100332
État
ID de l'ancien article	2682
Modèle	410-342
Fabricant	Digilent Inc.
Pays de fabrication	Taiwan
Contenu	1 pièce
Poids	28 g
Poids net	28 g

Pmod SSR: Solid State Relay Electronic Switch