Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod LS1

The Digilent Pmod LS1 allows users to receive signals from multiple optical sensors, such as the popular combination of an IR LED with an IR sensor used in line-following robots.

Features

Infrared light detector with on-board sensitivity adjustment
Interface with up to four reflective or transmissive photo detectors
Works with Digilent IR Proximity Sensor
Small PCB size for flexible designs 1.4“ × 0.8” (3.6 cm × 2.0 cm)
6-pin Pmod connector with GPIO interface
Follows Digilent Pmod Interface Specification Type 1

Scope of Delivery

1 x Pmod LS1

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: Pmod LS1 - Infrared Light Detector
Manufacturer's article number: 410-086

Resources

Other Digilent products are available on request.

Caractéristique technique	Valeur
ID de l’art.	100207
État
ID de l'ancien article	1902
Modèle	410-086
Fabricant	Digilent Inc.
Pays de fabrication	Taiwan
Contenu	1 pièce
Poids	15 g
Poids net	15 g

Pmod LS1 - Infrared Light Detector