Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod DA3

The Pmod DA3 is a 16-bit Digital-to-Analog converter powered by the Analog Devices AD5541A. The single ended SMA output provides a clean, guaranteed monotonic analog output from the provided information given through an interface similar to SPI.

Features

High resolution, 16-bit Digital-to-Analog converter
Low noise analog output
SMA connector
2.5V reference voltage
Small PCB size for flexible designs 1.2“ × 0.8” (3.0 cm × 2.0 cm)
6-pin Pmod connector with GPIO interface
Follows Digilent Pmod Interface Specification Type 1

Scope of Delivery

1 x Pmod DA3 in a custom antistatic Pmod packaging

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: PmodDA3: One 16-bit D/A Output
Manufacturer's article number: 410-241

Resources

Product page at Digilent Inc.
For datasheets, reference designs, and more, please visit the Analog Devices wiki.
Digilent Inc. Support Forum

Other Digilent products are available on request.

Item ID	100271
Condition	New
Legacy item ID	2050
Model	410-241
Manufacturer	Digilent Inc.
Manufacturing country	Taiwan
Content	1 piece
Weight	12 g
Net weight	12 g
Customs tariff number	84718090

Pmod DA3: One 16-bit D/A Output