LabVIEW Interaction Parts Kit

This kit contains all the parts you need to interface with the outside world using your LabVIEW-connected device!

Scope of Delivery

• LabVIEW custom cardboard box with protective foam
• 9x 240 ohm resistors 1/4W, 5%
• 2x 10K ohm resistors 1/4W, 5%
• 1x 1.0M ohm resistor 1/4W, 5%
• 1x 10K ohm potentiometer with thumbwheel 
• 2x 20K-30K ohm photoresistor, 150V, 100W
• 1x 100 µF electrolytic capacitor
• 1x WS2812 Addressable LED: 1M Waterproof Strip
• 4x 5mm green diffused LEDs
• 1x 5mm red diffused LED
• 1x IR LED
• 1x Phototransistor
• 1x Temperature and humidity sensor
• 1x Piezo buzzer/beeper
• 1x 8x8 Dot matrix display
• 1x 4-digit 7-segment display
• 1x Piezo sensor
• 1x Round force-sensing resistor
• 2x Momentary pushbuttons
• 1x Slide switch, 2.5mm spaced pins
• 1x Microphone
• 1x Low voltage temperature sensor
• 1x tilt sensor
• 1x Hall effect sensor
• 1x Tower Pro hobby servo motor + servo horns and screws
• 1x Wire kit, 70 pieces
• 1x 270 tie point breadboard with terminal strip
• Strip of 5 breakaway male headers

References

• Manufacturer: Digilent Inc.
• Manufacturer's article name: LabVIEW Interaction Parts Kit
• Manufacturer's article number: 6002-240-004

Resources

• Product page at Digilent Inc.
• Digilent Inc. Support Forum