Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod DHB1

The Pmod DHB1 uses the Texas Instruments® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals.

Features

Dual H-Bridge capable of 1.5A RMS
Two quadrature encoder channels for motor feedback
Two JST 6-pin ports for connection to Digilent motor/gearbox
Over-current protection
Recommended 10.8 V max motor voltage
Logic input voltage range of 2.5 V to 5 V
Small PCB size for flexible designs 1.3“ × 1.8” (3.3 cm × 4.6 cm)
Follows Digilent Pmod Interface Specification Type 5

Scope of Delivery

1 x Pmod DHB1 in a custom antistatic Pmod packaging

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: Pmod DHB1: Dual H-Bridge
Manufacturer's article number: 410-259

Resources

Other Digilent products are available on request.

Item ID	100277
Condition	New
Legacy item ID	2059
Model	410-259
Manufacturer	Digilent Inc.
Manufacturing country	Taiwan
Content	1 piece
Weight	22 g
Net weight	22 g
Customs tariff number	84718090

Pmod DHB1: Dual H-Bridge