Flexible peripheral modules for all your designs

Pmod™ devices are Digilent’s line of small I/O interface boards that offer an ideal way to extend the capabilities of programmable logic and embedded control boards. They allow sensitive signal conditioning circuits and high-power drive circuits to be placed where they are most effective - near sensors and actuators.

Pmod modules communicate with system boards using 6, 8, or 12-pin connectors that can carry multiple digital control signals, including SPI and other serial protocols. Pmod modules allow for more effective designs by routing analog signals and power supplies only where they are needed, and away from digital controller boards.

Overview Pmod CON3

The Pmod CON3 can be easily used to interface with up to four small servo motors that deliver anywhere from 50 to 300 ounce/inches of torque, such as those used in radio controlled airplanes or cars, as well as some mechatronics projects. The power supply can be sourced either from the system board or an external power source via a pair of screw terminals.

Features

Four standard 3-wire servo motor connectors
Easily interface with Digilent system boards
Flexible power delivery to servos
Small PCB size for flexible designs 1.0 in × 0.8 in (2.5 cm × 2.0 cm)
6-pin Pmod connector with GPIO interface
Follows Digilent Pmod Interface Specification Type 1

Scope of Delivery

1 x Pmod CON3

Pmod Hardware Compatibility Guide

Digilent's guide about determining hardware compatibility.

References

Manufacturer: Digilent Inc.
Manufacturer's article name: Pmod CON3: R/C Servo Connectors
Manufacturer's article number: 410-082

Resources

Other Digilent products are available on request.

Item ID	100226
Condition	New
Legacy item ID	1935
Model	410-082
Manufacturer	Digilent Inc.
Manufacturing country	Taiwan
Content	1 piece
Weight	12 g
Net weight	12 g
Customs tariff number	84718090

Pmod CON3: R/C Servo Connectors